|
Our High Intensity Mixer Bearing
Housings are cast with the mixing process and preventive
maintenance of a plant in mind. Our 500-600L units are built with a
Two-Piece Design below the mixer bowl. After removing the cap nut,
spacers, and tools, the operator simply needs to drop the lower
section of the Housing in order to get to the Bearings. The bowl
remains in place, drastically reducing any down time. Our larger
units maintain this same feature on the Mixer Side and add the same
Maintenance Friendly design on the motor side as well. After the
motor coupling is removed the Lower Housing simply drops down.
Connections on the motor remain intact and the motor itself stays
in place, saving hours of downtime.
Contact us about converting your
1-Piece Henschel Mixer Bearing Housing into a 2-Piece Bearing
Housing.
|
